By default OpenVPN only routes traffic to and from the OpenVPN Server. If you need all traffic from a client through the OpenVPN tunnel there are several options listed in the OpenVPN docs (http://openvpn.net/index.php/open-source/documentation/howto.html#redirect). Since I don’t have any control over the server in some cases I needed a client side solution. As I already have ufw running with Ubuntu I wanted to use the existing software.

Here is how to configure ufw to enable routing all traffic from your client machines through the OpenVPN Server.

Testing the RPi for some remote sensing application I needed to use a wireless connection as it would have been a pain to reach with an Ethernet cable.

Parts

• Raspberry Pi Series B 512MB
• Raspbian 3.6.11+ Kernel
• Comfast 802.11n – Realtek RTL8188CUS WLAN Adapter

Install WPA Supplicant

sudo apt-get install wpasupplicant

See http://en.wikipedia.org/wiki/Wpa_supplicant

Check for the USB adapter

sudo lsusb

This should show output similar to this (depending on your USB adapter)

Just a short note on Wireshark install (needed to beat an Asterisk SIP install into submission)

sudo apt-get install wireshark
sudo useradd -U -M -s /bin/false wireshark
sudo chgrp wireshark /usr/bin/dumpcap
sudo chmod 754 /usr/bin/dumpcap
sudo setcap 'CAP_NET_RAW+eip CAP_NET_ADMIN+eip' /usr/bin/dumpcap
sudo gpasswd -a YOURUSERNAME wireshark

Source: http://wiki.wireshark.org/CaptureSetup/CapturePrivileges